Skip to content

Logitech wireless m195 Mouse driver

    Logitech wireless m195 Mouse driver and software

    Here you will get the latest  Logitech wireless m195 driver and software that support Windows and Mac OS

    Logitech Connection Utility

    This standalone version of the Logitech Connection Utility program is for use on Windows. It can be used to reconnect supported keyboards or mice with a replacement receiver, or to restore a lost connection.

    NOTE: This utility is for non-Unifying wireless products that are bundled with a receiver that doesn’t have a connect button.

    Logitech wireless m195 Mouse SetPoint Smart Installer Download (3.51 MB)

    please use the following steps:

    To reconnect your keyboard or mouse to its receiver

    1. Launch the Connection Utility, and then do one of the following:

    Without SetPoint installed (Windows only):
    Download, save and run the Connection Utility.

    With SetPoint 4.8 or below installed (Windows only):
    Click Start > Run > type “C:\Program Files\Logitech\SetPoint\Connect.exe” and press Enter.

    With SetPoint 6.0 or 6.15:
    Click Start > Run > type “C:\Program Files\Logitech\SetPointP\Connect.exe” and press Enter.

    With SetPoint 6.20 or above:
    Click Start > Run > type “C:\Program Files\Logitech\SetPointP\ConnectUtility.exe” and press Enter.

    2. Follow the onscreen instructions to reconnect your keyboard or mouse.

    If your keyboard or mouse still doesn’t connect:

    1. Verify that the keyboard or mouse is powered on.
    2. Make sure your batteries have enough power. Replace them

     

    Leave a Reply

    Your email address will not be published.